Description

WE HAVE OUR PROTOTYPE CAGE AVAILABLE TO BUY AT A REDUCED COST, THIS CAGE CAN BE PAINTED IN ANY COLOUR.

THIS PROTOTYPE WAS FITTED TO THE VEHICLE BUT OFFERED A LIMITATION ON SEAT POSITION AT FULL EXTENTION WITH RECLINER SEATS.

THIS IS SUITED TO EITHER A SHORTER DRIVER OR BUCKET SEATS.

RRP £1584 DELIVERED

REDUCED TO CLEAR £1272 DELIVERED

The well sought after GT3 Half Cage is now available at JP Cages!

We have replicated the  GT3 Cage  and then added our own querks to it using Curved gussets, X centre with harness bars and X rear in BS4-T45, the cage weighs approximately 17KG and uses existing mounting points in the car.

The cage is designed to line up with the existing points in the car.

The fitting process is as follows:

• Remove the Front seats
• Remove the rear seats
• Remove Rear trims and cut a slot 50mm from the step forward and 25mm above the top edge of the step ( request we send you the fitting video ) and refit once done.at
• Remove the rear trim which covers the strut tops
• Remove the nuts from the rear strut tops
• Remove B pillar hooks
• Remove Seat Belt covers on B pillar
• Place the 25mm spacer into the slot at the bottom of the B pillar for the front mounts of the cage.
• Place cage in the car through the passenger door by laying it face down with the rear legs pointing up, until the inner cage legs have cleared the centre console, then tip the cage back and push the rear of the cage behind the struts as far as possible to give clearance for the B pillar Hooks to go back on.
• Pull the cage forward dropping the rear mounts into place and loosely fit the nuts.
• Now you have the cage in place you can locate the front mounts and bolt them in tight before tightening the nuts at the back.
• Fit the plastic tube caps and refit all the relevant trim.
• Fit the seats and Enjoy.

This cage is produced using BS4-T45 lightweight roll cage tube to offer a more premium product for a premium car.

Available in a range of powder coated colours as listed.